35
10. Starting the charge process Output 2 and 3
For charging / discharging, or conditioning a pack, select
the desired program as described below, and then set
suitable values.
If the battery does have a balancer connector, connect the
balancer connector to the balancer input (BALANCER
CONNECTOR) of the charger.
Make sure for the right polarity.
From right handed to left side:
Pin 1 (GND): Ground = battery -,
Pin 2 (1): + cell 1, Pin 3 (2): + cell 2, Pin 4 (3): + cell 3
Connect the two pole power charging cable of the battery to
the charger output - BATTERY + with the right polarity.
Hold the START button pressed in for about two seconds,
and the charger display, if the balancer connector is
connected or not. With connected balancer connector the
single cell voltages can be displayed, see 16..
________________
________________BATTERY CHECK
WAIT PLEASE...
2
sec.
START
________________
________________
LP+12.0V
2
sec.
3 sec.
________________
________________**INFORMATION***
BALANCER CON.
________________
________________**INFORMATION***
BALANCER NOT CON
START
________________
________________
T y p e O U T P U T[ 2 ]
LiPo = 3 cells
INC
+
-
DEC
If a Li-battery is connected and the balan-
cer connector is not connected, the char-
ger will display the cell count of the Lithium
pack, which must be corrected manually,
if it is wrong..
START
2
sec.
________________
________________BATTERY CHECK
WAIT PLEASE...
! Caution ! Please
take great care to set
the correct cell
count. and the right
battery type. If you
make a mistake, the
battery could
explode and burst
into flames !
Press the START button again,
and the charger will assess the
battery.
2
sec.
2
sec.
________________
________________
Type OUTPUT[2]
LiPo = 3 cells
________________
________________
Type OUTPUT[2]
LiPo < 0 . 5 A
START
MODE
INC
+
-
DEC
INC
+
-
DEC
To Next Page
Loading...
