46
15. Screen displays
Capacity in mAh
Output 3
________________
________________
Man. 12:56 00321
0000mAh 0000mAh
Program
Output 1
Charge / discharge time
(min.:sec.) Output 1
Capacity in mAh
Output 1
The two-line liquid-crystal screen displays in a clear form the important information generated
during the charge / discharge process. The information remains visible on-screen until you
disconnect the battery that is being charged. Once you connect another battery for charging, the
previously displayed values are erased, and cannot be called up again.
16. On-screen monitor displays
The ULTRA TRIO PLUS 14 incorporates a wide range of protective and monitoring systems
designed to check the charger’s functions and monitor the state of its electronics. If any of the
unit’s critical limit values is exceeded, the charge process is switched off. Typical triggers would
be excessive voltage, excessive temperature or a depleted car battery.
If any of these problems should occur, the liquid crystal screen displays the cause of the error,
and the buzzer sounds to alert you.
________________
________________BATTERY CHECK
WAIT PLEASE...
Measuring process
When you hold the START button pressed in for about two
seconds, the charger measures the battery connected to
it. This message appears on the screen for one or two
seconds before the charge process is initiated.
Capacity in mAh
Output 2
Current in A
Output 3
________________
________________
R e s. 25m
+ 1.00 A + 1.00 A
Internal resistance in mOhm
Output 1
Current in A
Output 2
Battery Type and
battery voltage in V
Output 3
________________
________________
LP+4.00A 12.345V
LP12.4V NM05.4V
Battery Type
Output 1
Current in A Output 1
Battery voltage in V
Output 1
Battery Type and
battery voltage in V
Output 2
To Next Page
Loading...
