GRE KPCOR46 - Page 34

34
INSTALLATION OF THE SWIMMING POOL IN CONCRETE SLAB
- Prior to installing the pool, you need to create a reinforced concrete slab which is a minimum of 350 Kg/m³ and 15 cm thick. It must be a
perfectly at and horizontal slab.
- Perform a small dig, according to the measurements on the table.
MONTAŻ BASENU NA PŁYCIE BETONOWEJ
- Przed przystąpieniem do montażu basenu należy wykonać płytę betonową zbrojoną o minimalnej gęstości 350 kg/m³ i grubości 15 cm. Musi
to być idealnie płaska i pozioma płyta.
- Wykonaj niewielki wykop, zgodnie z wymiarami podanymi w tabeli.
INSTALLATION OF THE SWIMMING POOL IN CONCRETE SLAB
- Prior to installing the pool, you need to create a reinforced concrete slab which is a minimum of 350 Kg/m³ and 15 cm thick. It must be a
perfectly at and horizontal slab.
- Perform a small dig, according to the measurements on the table.
INSTALLATION OF THE SWIMMING POOL IN CONCRETE SLAB
- Prior to installing the pool, you need to create a reinforced concrete slab which is a minimum of 350 Kg/m³ and 15 cm thick. It must be a
perfectly at and horizontal slab.
- Perform a small dig, according to the measurements on the table.
INSTALAREA PISCINEI ÎN PLACĂ DE BETON
- Înainte de instalarea piscinei, trebuie să construii o placă de beton armat cu densitate minimă de 350 Kg/m³ și grosime de 15 cm. Trebuie să
e o placă perfect plană și orizontală.
- Executai o mică perforaie, conform măsurilor din tabel.
INSTALLATION AV SWIMMINGPOOLEN PÅ BETONGPLATTA
- Innan du installerar poolen måste du skapa en armerad betongplatta som är minst 350 kg / m³ och 15 cm tjock. Det måste vara en helt platt
och horisontell platta.
- Utför en liten grävning enligt måtten på bordet.
680cm 540cm
400cm 360cm
400cm 400cm
400cm
260cm
KPCOR28
KPCOR46
KPCOR2814
KPCOR60L
KPCOR60
PL
EN
CS
SK
RO
SV