GRE SP7212 - Page 2

SHOWER INSTALLATION:
‐Placetheshowerplateonastableandhorizontalsurface.
‐Connectthegreenadaptertotheplatform(Figure1and2).Checkthevalveoftheadapterthat
controlsthewaterflowisinONposition(Figure3)
‐Connectthegardenhose(Figure4)
‐Openwatersourceto75%
ofmaximumflow.Ifyouneedhigherwaterheightincreasethewater
flow.However,ifthepressureistoohigh,theadaptermightdisengagefromtheplatform.
‐Totestwaterheightstepontocenterofplatform,yourweightwillopenthesprayvalves.If
waterheightistoolowgo
backtowatersourceandopenyourwatervalvemore.Tolowerthe
waterheight,adjustthevalveongreenadapter.
Figure 1 Figure 2
Figure 3 Figure 4
RECOMMENDATIONS:
Duringhotdays,releasesomewaterfromthegardenhosebeforeconnectingtotheplatformto
avoidgettingbu rned.
In winter you MUST empty completely the shower, and if you are unsure, we recommend to store
the shower inside your garage.
Fornormaluse,thepressureofyourwatershouldbeminimum2bars.Forapressureabove4bar,
pleaseuseapressurereducer.
EN