Operating Procedures / Photos
4.Disassemble the electrical box cover
Screw off screw from the electrical box cover
then can disassemble the electric box cover.
Electric box cover
Mainboard
Screw
Earth screw
Tube sensor
5.Disassemble electric box
Screw off screws on electric box, screw off
earth screw, pull out tube sensor, mainboard,
LCD, air guide motor, wire terminal of motor,
then can take down the electric box.
6.Disassemble evaporator
Screw off screws from evaporator, and loosen clasp,
can take down the motor clamp.
Screw off one screw from the evaporator and motor clamp,
can take down the motor clamp.
Motor clamp
Clasp
Screw
To Next Page
Loading...
