Operating Procedures / Photos
Disassembly procedures for indoor unit
Dissassembly Procedures
Dissassembly Procedures
77
77
7
Front
Front panel
Filter
Top cover
Air guide board
Bearing sleeve
Screw
Clasp
1.Disassemble the front panel
Open the front panel, slightly press the axial of both sides,
then to make the axial slide, can take down the front panel.
Push the filter onwards, can take down the front panel.
Push the filter, can take down the filter.
Unscrew one screw from top cover, can take it down.
2.Disassemble the air guide board
Use the screwdriver to pushthe axial,
hold both side of air guide board. Then can
3.Disassemble the front case
Open the screw cover, screw off 5pcs screw
fix on the front case, loosen the rear clasp,
lift it up, can take down it.
take them down.
To Next Page
Loading...
