4. Disassemble Electric Box
Unscrew the screws fixing the electric box, and
then pull out the inset block of lead-out wire of
compressor and fan motor to take out the electric
box.
Operating Procedures / Photos
Loosen the fastening nut fixing the axial flow fan
with a spanner, and then take out the nut, spring
gasket and flap gasket in turn.
Unscrew the 4 screws fixing the motor to take out
the motor,and then unscrew the 2 screws fixing the
motor support to take it out.
5. Disassemble Axial Flow Fan
6. Disassemble Motor and Motor Support
Screws
Nut
Motor
Motor Support
To Next Page
Loading...
