Fengyun Series
Operation Process / Photoes
Disassemble Motor
Use a screwdriver to unscrew the two screws fixing the motor
clamp
and then remove the motor clamp. Unscrew the 3 holding
screws on the bearing cover and remove the motor.
(refer to Figure 7-11,7-12)
Figure 7-11
clamp
screws
Disassemble Cross Flow Fan
T
ake out the bearing holder at the left, and remove the
cross flow fan.
(refer to Figure 7-13)
Bearing Holder
Figure 7-12
Figure 7-13
screws
screw
motor
Cross Flow Fan
Cross Flow Fan
To Next Page
Loading...
