GREE DC INVERTER HEAT PUMP CONDENSING UNIT
93
NOTE: Before removing the fan, make sure power is cut off.
Replace with a new motor.
Then tighten up the screw
bolt.
Install the fan in place. Put
on the gasket and use a
wrench to secure the screw
nut.
NOTE:After installing the
fan, turn the fan by hand to
see if it can run normally. If
not, please check for the
reason.
After replacing the motor,
use a screwdriver to tighten
up the screw bolt that
secures the motor.
To Next Page
Loading...
