Gree GJC05BJ-A3MNE1A - Air Conditioner Use; Controls Overview; Remote Control Functions

6
AIR CONDITIONER USE
Controls
Mode Pad
Use to set the air conditioner to
or mode.
Each touch of the
pads on the unit or the
pads on the remote control will set the delay
time when using the timer (
The light will turn on while setting.
Use to set the fan speed to
or on the unit On the remote
control, use the fan speed
pads to set the fan speeds to
or . Use the pad to turn
fan on.
Cool, Energy
Saver Fan Only
control panel indicate the selected settings.
Remote Control
The display always shows the room
temperature except when setting the
Set temperature or the Delay timer
.
Air Conditioner Controls
Light indicates the
delay timer is set.
Light indicates the unit
is in the temperature or
delay time Set mode.
Display
Shows the room temperature or time
remaining on the Delay timer. Shows the
temperature while setting the temperature in
or modes. The light will
turn on while setting.
The display will change to show the
room temperature after settings have been
made. To the temperature, press the
or pads.
Use to set temperature when in or
mode. The light will turn on while
setting.
change
Set
Cool Energy Saver Set
NOTE:
Set
Temp Increase ▲ Decrease ▼
Temp Increase ▲ /Decrease ▼ Pads
Cool Energy
Saver Set
Delay Timer Increase ▲ (+) /Decrease ▼ (–)
Pads
Increase ▲ / Decrease ▼
Increase
+ / Decrease –
Delay 1–24hr ).
Set
Fan Speed Pads
Low, Med, High
Auto . NOTE:
Increase
+
/
Decrease –
Low
,
Med High Auto Auto
Power Pad
Turns air conditioner on and off. When
turned on, the display will show the room
temperature.
Lights next to the touch pads on the air conditioner
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■ If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
■ Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will
operate properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
Starting Your Air Conditioner—
Digital Control
Delay 1–24hr
Delay timer
Decrease
Mode select
Fan speed
Decrease
Temperature
set Increase
and Decrease
Delay timer Increase
Auto Fan on
Fan speed Increase
Unit power on/off