Gree GJC05BT-A6NRNE1A - Remote Controller Operation

4
MODE button
Press this button can select your required operation mode in turn.
● After selecting cooling mode, air conditioner will operate under cooling mode.Cooling indicator on control panel will be on.
Press “
∧
” or “
∨
” button to adjust set temperature. Press “Fan-” or “Fan+” button to adjust fan speed.
●
After selecting fan mode, air conditioner only blow wind, not cooling or heating. Fan indicator on control panel will be on.
Press “Fan-” or “Fan+” button to adjust fan speed.
●
After selecting SE mode, air conditioner will operate under SE mode. SE indicator on control panel will be on.
Press “
∧
” or “
∨ ” button can adjust set temperature. Press “Fan-” or “Fan+” to adjust fan speed.
Cool
Fan
Only
Energy
Save
Introduction of remote controller
Note:
This is a general use remote controller, it could be used for the air conditioners with multifunction; For some function,
which the model dosen’t have, if press the corresponding button on the remote controller that the unit will keep the
original running status.
1
2
3
4
5
6
7
1
ON/OFF button
2
Fan+ / Fan- button
3
∧
/
∨
button
4
MODE button
5
SLEEP button
6
+ / - button
7
DELAY button
Fan
Fan
-
SLEEP
MODE
DELAY
ON/OFF
+
1
ON/OFF button
Press this button can turn on or turn off the air conditioner.The unit defaults to operate under SE mode when turning the unit at OFF status.
2
Fan- / Fan+ button
Press fan- button to decease fan speed; press fan+ button to increase fan speed.
3 ∧
/
∨
button
After each pressing of “
∧
” button or “
∨
” button, temperature will increase or decrease1°C(1°F). If hold “ ” button or
∧
“
∨
” button, 2s later, set temperature displayed on dual-8 nixie tube will change quickly. Loosen the button after it has
13
reached to your required temperature.