14
© Copyright, GREE Canada, 2017
Clean and Maintenance
WARNING!
1) Turn off the air conditioner and disconnect the power before cleaning the air conditioner to avoid
electric shock.
2) Do not wash the air conditioner with water to avoid electric shock.
3) Do not use volatile liquid to clean the air conditioner.
!
CLEAN FILTER
1) Open the panel. Pull the groove at both
sides of panel forcibly to open the panel
to a certain angles as shown in the
illustration.
2) Remove the lter as show in the
illustration.
3) Clean the lter
• Use dust catcher or water to clean the
lter.
• If the lter is very dirty, you can use warm
water dissolved with neutral abluent, and
then put it under the shady place.
4) Install the lter and then buckle the panel
cover tightly.
NOTICE:
• Clean the lter about once every three month. If there are lots of dust in operation
environment, you can increase the clean times.
• Due to there’s shaft metal ns in the air conditioner, do no touch the ns after
removing lter to avoid scratching.
• Do not dry the lter on re or use hair drier to dry the lter. Otherwise, the lter may
be deformed or catch re.
• Do not operate the air conditioner when the lter hasn’t been installed.
Note:
Do not remove the panel when cleaning it.
Note:
In order to reduce damage or rust under no-use season, you can cover the air
conditioner with protective covering.
If the surface of panel is very dirty, you are suggested to use soft dry cloth or wet cloth
dipped with neutral abluent to wipe it.
You are suggested to check the outer case of air conditioner one or twice every year. If the
outer case is damaged or rusted, please contact dealer.
CLEAN THE PANEL
MAINTAIN THE OUTER CASE
To Next Page
Loading...
