Gree GPC12AL-K3NNA1A - Heat Discharge Pipe Installation and Removal

25
Maintenance
Service Manual
A. Install heat discharge pipe
(1) Rotate joint A and joint B clockwise into the two ends of heat discharge
pipe.(As show in Fig.10)
(2) Insert joint A of heat discharge pipe (the side with "TOP" is upwards) into
the groove until you hear a sound.(As shown in Fig.11)
(3) Lead the exhaust hose outdoors.(As shown in Fig.12)
clockwise
clockwise
j
oint A
joint B+C
heat discharge pipe
8.3 Installation and Disassembly of heat Discharge Pipe
groove
clasp
the side with "TOP" is upwards
In order to improve cooling efciency, the heat discharge pipe should be as short as possible and at without curve to ensure smooth
heat discharge.(As shown in Fig.13)
●The length of the heat discharge pipe is less than 1m. It is recommended to use it with shortest length.
●The length of the heat discharge pipe is less than 1m. It is recommended to use it with shortest length.(As shown in Fig.14)
●Correct installation is as shown in gure (When installing it on wall, height of hall should be about 40cm-130cm from oor).(As shown
in Fig.15)
●Wrong installation is shown in following gure (If the pipe is bent too much, it would easily cause malfunction.(As shown in Fig.16)
Note of Install heat discharge pipe
130cm
40cm
correct correct
correct
wrong
Fig.10
Fig.12
Fig.11
Fig.14
Fig.15
Fig.16
Fig.13