Gree GRS-1.5/TD200ANbA-K - Page 40

GREE AIR SOURCE HEAT PUMP WATER HEATER SERVICE MANUAL
38
③ Remove the 6 fixing screws on the front outer case subassembly;
④ Remove the front outer case subassembly;
⑤ Remove the 3 fixing screws of the gland of wired controller ;
⑥ Remove the gland and wired controller (please keep the gland of wired controller properly for
future use);
Please change the original short communication cable with long communication wire, which is led
out from the cable-crossing hole of unit;
⑦ Install decoration cover;
⑧ Tighten the fixing screw of decoration cover;
⑨ Install the front outer case subassembly;
⑩ Tighten the 6 fixing screws of front outer case subassembly;
⑪ Install the upper cover;
⑫ Tighten the fixing screw of upper cover;
⑬ Connect the wired controller with long communication cable and then install the wired controller on
the wall;