Unit Control
48
When the unit is
ON
, the green indicating LED located at the upper right of the control will light
on. When the unit is
OFF
, the green indicating LED will light off.
[Notes]
①
The unit is defaulted to be
OFF
when energized for the first time.
②
The
ON/OFF
key operation works only at the home page and the standby page.
③
When the “
Holiday mode
” or the “Emergen.mode” is activated, the
ON/OFF
key
operation will become ineffective.
④
When the
“Forced Heating
” or “
Forced Cooling
” is activated, it will be deactivated by
pressing the “
ON/OFF
” key , and then press the
ON/OFF
key again to start the
unit.
⑤
ON/OFF
operation will be memorized by setting “
On/off Memory
” to be “
On
” at the “
GEN
.”
setting page. That is, in case of power failure the unit will resume running upon power recovery.
Once “
On/off Memory
” is set to be “
Off
”, in case of power failure the unit will keep “
Off
” upon
power recovery.
⑥
At the home page, the
ON/OFF
key is intended to turn on/off the unit if applicable. The
Function keys no.1 to no.4 are corresponding to “
FUNC
.”, “
PAPA
”, “
VIEW
” and “
GEN
.” setting
pages respectively.
⑦
At the standby page, the Menu key is used to back to the homepage, the
ON/OFF
key
is used to turn on/off the unit if applicable, and all other key operations are ineffective.
⑧
The control will return automatically to the homepage where there is no any key operation in 10
consecutive minutes.
3.2.2 Function Setting
It enables the user to set each function.
[Operation Instructions]
1. At the homepage, by pressing the Function key no. 1 , the control will access to the
FUNCTION
page 1, as shown in the figure below.
To Next Page
Loading...
