Unit Control
76
At the version view
page
, the user is enabled to see the version of the program and the protocol.
[Operation Instructions]
1. At the
VIEW
page, select
Version
and then press the OK key to go to the
VERSION
page.
2. At the
VERSION
page, the program and protocol versions are listed.
3. 2.5 General Setting
At the general setting pages, the user is enabled to configure general parameters, like temperature
unit, language, On/off memory, time & date etc.
[Operation Instructions]
At the homepage, by pressing “
GEN
.” access to the GENERAL SET page. At this page, it is
able to set “
Temp. unit
”, “
Language
”, “
On/off memory
”, “
Time & Date
”, “
Beeper
” and “
Back light
”, as
shown in the figure below.
To Next Page
Loading...
