Gree GUD71ZD/A-T

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
119
Removal of fan and motor
Note: Before removing the motor, make sure power is cut off.
Step
Picture
Work instruction
6. Replace the motor.
●Remove the motor from the motor
support.
●Use a hex wrench to loosen the
screws of fan.
●Remove the fan from the motor.
●Replace with a new motor.
7. Re-install the device in
a reverse order of the
removal procedure.
●Re-install the device in a reverse
order of the removal procedure.
Then connect power and test it.
Removal of air return filter
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components. Do not place
the filter near any heat source.
Step
Picture
Work instruction
Remove air return
filter.
●Press the air return filters on the
guide way sponge. There are 2 or 3
air return filters.
Removal of the cover of electric box and the electric box
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components, especially the
electric components. Do not hit or beat.
Step
Picture
Work instruction
1. Remove the cover
of electric box.
●Loosen the screws as shown by
the circle and the box. Remove the
box in the direction shown by the
arrow.
2. Remove the
electric box.
●Loosen the securing screws and
remove the electric box.