DC Inverter U-match Series Cassette Type Unit
21
(2). Improper screwing of the screws may cause the troubles shown in Fig.35.
Condensate
Fig.35
(3). If gap still exists between ceiling and decoration panel after tightening the screws, readjust
the height of the indoor unit. (Fig.36)
Fig.36
(4). Wire the swing ap motor as shown in Fig.37.
Fig.37
4.6.2 Installing the Panel
(1). Place the panel at the unit, and latch the hooks beside and opposite the swing ap motor.
(2). Latch other two hooks.
(3). Tighten four hexagonal screws under the latches about 15mm.
To Next Page
Loading...
Need help?
General
