U-Match Series DC Inverter Service Manual
127
1. Discharge the refrigerant inside the pipeline and
recycle the refrigerant during discharging;
2. Unsolder the 4-way valve assy from
compressor;
3. Remove the nut fixing compressor;
4. Take away the compressor from chassis.
Assemble the unit in the reverse procedures of
disassembly.
Remark: Before disassembly and assembly, make sure that the unit has been cut off from the power supply.
1. Remove external
casing
1. Remove the top cover and handle;
2. Remove the grille, outer case and right side
plate.
1. Remove the blade nut and then remove the
blade;
2. Remove the motor from motor support.
To Next Page
Loading...
