7HFKQLFDO,QIRUPDWLRQ
6HUYLFH0DQXDO
21
22
23
24
20
Up & down swing icon:
is displayed when pressing the up & down swing button. Press this button again to clear the displa y.
Left & right swing icon:
is displayed when pressing the left & right swing button.Press this button again to clear the displa y.
SET TIME display:
After pressing TIMER button, ON or OFF will blink.This area will show the set time.
DIGITAL display:
This area will show the set temperature. In SA VE mode,"SE" will be displayed. During defrosting operation, “H1” will be display ed.
F AN SPEED display:
Press F AN button to select the desired fan speed setting(AUT OLow-Med-High).Y our selection will be displayed in the LCD windows,
except the AUTO fan speed.
1
2
3
4
5
6
7
8
ON/OFF:
Press this button to turn on the unit. Press this button again to turn of f the unit.
MODE:
Each time you press this button,a mode is selected in a sequence that goes from AUTO, COOL,DRY , F AN, and HEAT *, as the
following:
*Not e: Only for models wi th heating function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not be displayed on the LCD, and the unit wi ll
automatically select the suitable operation mode in accordance with the room temperature to make indoor room comfortable.
+ :
Press this button to increase set temperature. Hold it down for above 2 seconds to rapidly increase set temperature. In AUTO mo de,
set temperature is not adjustable.
-:
Press this button to decrease set temperature. Hold it down for above . 2 seconds to rapidly decrease set temperature. In AUTO
mode, set temperature is not adjustable.
F AN :
This button is used for setting fan speed in the sequence that goes from AUTO, , , to then back to Auto.
●Press button to start or stop up & down swing function.The remote controller defaults to simple swing condition.
●Press + button and button at the same time at unit OFF to switch between simple swing and static swing; blinks for 2
seconds.
●In static swing condition, pressing button, the swing angle of up & down louver changes as below:
●If the unit is turned of f during swing operation,the louver will stop at present position.
HEAL TH SA VE
Press HEAL TH part of this button to turn on or of f HEAL TH function.Pressing SA VE part of this button, is displayed and the unit
goes into SA VE operation mode. Press SA VE part of the button again to cancel SA VE function. During SA VE operation, the temp-
erature and fan speed is not adjustable.
●Press button to start or stop left & right swing function.The remote controller defaults to simple swing condition.
●Press + button and button at the same time at unit OFF to switch between simple swing and static swing; blinks f or 2
To Next Page
Loading...
