9
Hex nut diameter
15~20
30~40
45~55
60~65
70~75
●
4.
Tightening torque (N
.
m)
drain hose
1.
Add insulating pipe in the indoor drain hose in order
to prevent condensation.
The plastic expansion particles are not provided.
2
.
2.
outlet pipe
tape
NOTE
●
Connect wire of indoor unit
Step 7:
cable-cross
hole
power connection
wire
Step 6:
Install drain hose
1.
insulating pipe
insulating pipe
Bind the joint with tape .
drain hose
indoor unit.
Wrap the indoor pipe and joint of connection
pipe with insulating pipe, and then wrap it
with tape.
outlet
pipe
drain hose
●
All wires of indoor unit and outdoor unit should be
●
If the length of power connection wire is insufficient,
●
●
connected by a professional.
Open the panel, remove the screw on the wiring
cover and then take down the cover.
please contact the supplier for a new one. Avoid e-
xtending the wire by yourself.
NOTICE
Connect the drain hose to the outlet pipe of
For the air conditioner with plug, the plug should be
reachable after finishing installation.
For the air conditioner without plug, an air switch
must be installed in the line. The air switch should
be all-pole parting and the contact parting distance
should be more than 3mm.
Make the power connection wire go through the
cable-cross hole at the back of indoor unit and
then pull it out from the front side.
panel
wiring cover
screw
To Next Page
Loading...
