Clean and maintenance
2.
■
2.
■
4.
WARNING
WARNING
■
■
■
■
■
Clean filter
1.
Please contact qualified professionals for
service.
NOTICE: Checking after use-season
Check whether air inlets and air outlets are bl-
Error Code
Error code
3.
●
●
F2
NOTE
●
Do not remove the panel when cleaning it.
NOTICE
●
3.
4.
E8
1.
1.
2.
3.
Open panel
Pull out the panel
to a certain angle
as shown in the fig.
NOTICE: Checking before use-season
C5, F0, F1,
Troubleshooting
Notice for recovery
2.
Remove filter
Remove the filter as
indicated in the fig.
U8, H6, H3,
1.
E1, E5, E6,
Install filter
Install the filter and then close the panel cover
tightly.
11
ocked.
Check whether air switch, plug and socket are
If there're other error codes, please contact qu-
alified professionals for service.
Clean surface of indoor unit
When the surface of indoor unit is dirty, it is recomm-
ended to use a soft dry cloth or wet cloth to wipe it.
5.
Disconnect power supply.
Clean filter and indoor unit’s panel.
Many packing materials are recyclable mate-
Check whether drainage pipe is damaged.
Check whether mounting bracket for outdo
or
unit is damaged or corroded. If yes, please
contact dealer.
in good condition.
Check whether filter is clean.
Check whether mounting bracket for outdoor
unit is damaged or corroded . If yes, please
contact dealer.
The filter should be cleaned every three months .
If there is much dust in the operation environme-
nt, clean frequency can be increased.
After removing the filter, do not touch fins to
avoid injury.
Do not use fire or hair dryer to d
ry the filter to
avoid deformation or fire hazard.
When air conditioner status is abnormal, tempe-
rature indicator on indoor uni t will blink to display
corresponding error code. Please refer to below
list for identification of error code.
It can be eliminated after restarting the unit.
If not, please contact qualified professionals
for service.
e tairporppa ni meht esopsid esaelP .slair
recycling unit.
esaelp ,renoitidnoc ria eht esopsid ot tnaw uoy fI
contact local dealer
or consultant service center
for the correct disposal method.
Clean filter
Use dust catcher or water to clean the filter.
When the filter is very dirty, use the water
(below 45℃) to clean it , and then put it in a
shady and cool place to dry.
Turn off the air conditioner and disconnect the
power before cleaning the air conditioner to av-
oid electric shock.
Do not wash the air conditioner with water to
avoid electric shock.
Do not use volatile liquid to clean the air
conditioner.
Do not use liquid or corrosive detergent to clean
the appliance and do not splash water or other
liquid onto it , otherwise, it may damage the
plastic components , even cause electric shock.
To Next Page
Loading...
