20
●
This function is only available for some models.
NOTE
Night mode
●
●
●
NOTE
●
Under cooling or heating mode, when turning on
sleep mode and turn to low speed or quiet notch,
the outdoor unit would enter into night mode.
The
auto clean function can only work under normal
ambient temperature. If the room is dusty, clean it
once a month; if not, clean it once every three
months. After the auto clean function is turned on,
you can leave the room. When auto clean is finished,
the air conditioner will enter standby status.
When you feel that the cooling and heating effect is
poor, please press "Fan" button to other fan
speed
or press "Sleep" button to exit the night mode.
The night mode can only work under normal ambient
temperature.
This function is only available for some models.
●
NOTE
This function is only available for some models.
I FEEL function
●
●
●
NOTE
Auto clean function
Press "Health" and " + " buttons simultaneously to
start I FEEL function and " " will be displayed on
the remote controller. After this function is set, the
remote controller will send the detected ambient
temperature to the controller and the unit will
automatically adjust the indoor temperature
according to the detected temperature. Press
"Health" and " + " buttons simultaneously again to
turn off I FEEL function and " " will disappear.
Under unit off status, hold "Mode" and " "
buttons simultaneously for 5s to turn on or turn off
the auto clean function. When the auto clean func-
tion is turned on, indoor unit displays "CL" . During
the auto clean process of evaporator, the unit will
perform fast cooling or fast heating. There may be
some noise, which is the sound of flo
wing liquid or
thermal expansion or cold shrinkage. The air con-
ditioner may blow cool or warm air, which is a
normal phenomenon. During cleaning process,
please make sure the room is well ventilated to
avoid affecting the comfort.
Please put the remote controller near user when
this function is set. Do not put the remote con-
troller near the object of high temperature or low
temperature in order to avoid detecting inaccu-
rate ambient temperature.When I FEEL functio
n
is turned on, the remote controller should be put
within the area where indoor unit can receive
the signal sent by the remote controller.
Two-way ventilation function
If the set temperature and the fan speed have been
adjusted during the operation under fast cooling
mode, the unit will exit from the fast cooling mode.
Then the indoor unit operates continuously under
the adjusted status.
Fast cooling function is only applicable for some
models. If this function is unavailable for this indoor
unit, 20 minutes later, the remote controller will turn
back to the status before fast cooling. Indoor unit
operates continuously according to current status. At
this time, status of indoor unit and the display status
on the remote controller may be different.
This function is only available for some models.
Under turning on，press "Mode" and "Health"
buttons simultaneously to start up or turn off
two-way ventilation function.When two-way
ventilation funct ion is started up, will be
shown on remote controller, and the light of the
two-way ventilation system is turned on. Fan
speed will be adjusted according to the fan
speed of air conditioner.
Under turning off，press "Mode" and "Health"
buttons sim
ultaneously to start up or turn off
t wo-wa y v e n t i l a t i o n f u n c t i o n onl y . W h e n
two-way ventilation function is started up,
will be shown on remote contro ller, and the
light of the two-way ventilation system is turned
on. Fan speed will be adjusted according to fan
button on remote controller.
To Next Page
Loading...
