Gree GWH09MB-K3DNA2H/I(DRED) - Indoor Unit Installation; Choosing Installation Location; Install Wall-Mounting Frame; Open Piping Hole

24
Installation of indoor unit
Step one: choosing installation location
Step two: install wall-mounting frame
Recommend the installation location to the client and then conrm it with the client.
1. Hang the wall-mounting frame on the wall; adjust it in horizontal position with the
level meter and then point out the screw xing holes on the wall.
2. Drill the screw xing holes on the wall with impact drill (the specication of drill
head should be the same as the plastic expansion particle) and then ll the
plastic expansion particles in the holes.
3. Fix the wall-mounting frame on the wall with tapping screws (ST4.2X25TA) and
then check if the frame is rmly installed by pulling the frame. If the plastic
expansion particle is loose, please drill another xing hole nearby.
1. Choose the position of piping hole according to the direction of outlet pipe. The
position of piping hole should be a little lower than the wall-mounted frame,
shown as below.
Step three: open piping hole
2. Open a piping hole with the diameter of Φ55 or Φ70 on the selected outlet pipe
position. In order to drain smoothly, slant the piping hole on the wall slightly
downward to the outdoor side with the gradient of 5-10°.
Left
Wall
Φ55mm
Right
Mark in the middle of it
Level meter
Rear piping hole
Wall
Space
to the
wall
above
150mm
Space
to the
wall
above
150mm
Φ55mm
Rear piping hole
24
、
28K:
Left
Wall
Φ70mm
Right
Mark in the middle of it
Level meter
Rear piping hole
Wall
Space
to the
wall
above
150mm
Space
to the
wall
above
150mm
Φ70mm
Rear piping hole
18K:
09 12K:
24K:
Left
Wall
Φ55
Right
Mark in the middle of it
Level meter
Rear piping hole
Wall
Space
to the
wall
above
150mm
Space
to the
wall
above
150mm
Φ55
Rear piping hole
Left
Wall
Φ70mm
Right
Mark in the middle of it
Level meter
Rear piping hole
Wall
Space
to the
wall
above
150mm
Space
to the
wall
above
150mm
Φ70mm
Rear piping hole
、