109
Installation and Maintenance
Service Manual
11. Removal Procedure
11.1 Removal Procedure of Indoor Unit
Caution: discharge the refrigerant
completely before removal.
Step Procedure
1. Remove lter
Open the panel. Loosen the clasp shown and then
pull the left lter and right ler outwards to remove
them.
2. Remove horizontal louver
Push out the axile bush on horizontal louver. Bend
the horizontal louver with hand and then separate
the horizontal louver from the crankshaft of step
motor to remove it.
Panel
left lter and right ler
Axile bush
Horizontal louver
NOTE: Take YC model for example.
To Next Page
Loading...
