19
●
NOTE
This button is only available for the model with such
function.
This function is only available for some models.
●
●
NOTE
Clean reminder function of filter
Indoor ambient temperature or humidity display
indoor units enter into power limiting mode, then
the power of outdoor unit will be limited according
to the lower power of the two indoor units.
By holding " On/Off " and " " buttons simultane-
ously , you can see indoor ambient temperature or
indoor ambient humidity on indoor unit’s display. The
setting on remote controlleris selected circularly as
below:
The reminder function is defaulted to be OFF. Hold
" On/Off " and " " buttons simultaneously for 5s
to turn it on. The buzzer will give out sound for 0.5s
and the dual-8 nixie tube on the display will be on
for 3s; Once the reminder function is turned on,
when the air conditioner has reached to the set
time, the dual-8 nixie tube will flash about 30s
when the unit is turned on each time to remind the
user to clean the filter; you can turn off t
his cycle
reminder by holding " On/Off " and " " buttons
simultaneously for 5s and then the air conditioner
will count time again.
blank
No Setting
Once the reminder function is turned on, only this
cycle reminder can be cleared.
●
●
NOTE
When selecting " " with remote controller,
temperature indicator on indoor unit displays
indoor ambient temperature.
When selecting " " with remote controller,
temperature indicator on indoor unit displays
indoor ambient humidity.
This function is only available for some models.
●
NOTE
Volume control of IDU Buzzer
Fast cool function
Press "
Mode
" and " " buttons simultaneously
to reduce the sound level of the indoor unit'
buzzer.
The ambient humidity value is only for reference. Eg:
If humidity value is "0%", there may be malfunction
for the humidity detection board. Please contact local
service provider.
There may be some measuring deviation for humidity
detection and photosensitiveness detection.
Press " On/Off " and " + " buttons simultaneously
under cooling mode can select 25
℃
(77
℉
) fast cool-
ing mode, 16
℃
(61
℉
) fast cooling mode and normal
cooling mode circularly. " " icon will be displayed
on the remote controller under fast cooling mode.
Once it enters into fast cooling mode, the fan speed
is auto fan and the set temperature is 25℃(77℉) or
16℃(61℉). At this time, the
set temperature flash-
es to display for 5s. In the flashing period, press
" + " or " - " button to adjust the set temperature.
Press "Fan" button to adjust the fan speed. If the
set temperature and the fan speed haven't been
adjusted during that time, the remote controller and
the indoor unit will operate under current set tem-
perature and fan speed for 20 minutes. 20 minutes
later, the set temperature and the fan speed for the
remote controller and the indoor unit will turn to the
status before quick cooling.
blank
No Setting
●
●
●
●
the remote controller will circularly display as the
following:
●
For the model with one outdoor unit and two indoor
units, if any one of indoor units enters into power
limiting function, the outdoor unit will enter into the
set limiting power mode of indoor unit; when two
Maximum power limited under the mode is
lower than that of mode.
If you want to cancel the power limiting function,
press "Mode" and "Sleep" buttons simultaneously
till the icon in remote controller is not displayed.
When the remote controller is turned off, power
limiting function is cancelled. If you want to
activate the function, please repress "Mode" and
"Sleep" buttons simultaneously.
If the current power is lower than the maximum
power of mode, then the power will not be limit-
ed after entering into such mode.
To Next Page
Loading...
