107
Installation and Maintenance
Service Manual
sticking
stripe
soundproof
sponge
7.remove the isolation plate and reactor
Remove the 2 screws connecting the isolation
plate and condenser side plate; remove the
3 screws connecting the isolation plate and
chassis, and then remove the isolation plate.
Remove the 4 screws connecting the reactor
and isolation plate, and then remove the reactor
reactor
isolation plate
a
b
screws
screws(Note: these two screws are
at the side of motor support)
screws
screws
6.remove the soundproof sponge.
Tear off the sticking stripe and then remove the
soundproof sponge.
ProcedureStep
To Next Page
Loading...
