96
Installation and Maintenance
Service Manual
Motor
Screw
Screw
Motor support
Remove the screws xing motor and then
remove the motor.
9.Remove motor
Remove the screws xing motor support
and then remove the motor support.
10.Remove motor support
Spot weld
4-way valve assy
11.Remove 4-way valve assy
Unsolder the spot weld of 4-way valve assy,
compressor and condenser, and then remove
the 4-way valve assy .
Note:
When unsoldering the spot weld, wrap the
4-way valve with wet cloth completely to avoid
damaging the valve due to high temperature.
Procedure
Step
To Next Page
Loading...