101
Installation and Maintenance
Service Manual
Step Procedure
10. Remove axial ow blade
Remove the nut on the blade and then remove the axial
ow blade.
11. Remove motor and motor support
Remove the 4 tapping screws fixing the motor and
disconnect the leading wire insert of the motor. Then
remove the motor. Remove the 2 tapping screws xing
the motor support and chassis, and then lift the motor
support to remove it.
12. Remove electric box assy
Remove the screws xing the electric box assy and the
middle isolation sheet, loosen the wire bundle, unplug
the wiring terminals, and then lift the electric box assy
to remove it.
11. Removal Procedure
Axial ow blade
Motor support
Electric box assy
Motor
To Next Page
Loading...
