Hydro Box
29
4.8.5 Water discharge of hydro box
(1) Use a screwdriver to unscrew the 9 screws of the top cover of the hydro box and the 4
screws at the bottom of the rear panel (the side panel without the GREE logo), and then
remove the top cover and the rear panel;
Fig.4.23
(2) Operate from the direction shown in the figure below. Loosen the drain valve and the
exhaust valve installed on the outlet water pipe.
Fig.4.24
(3) Start draining and finish draining when no water comes out of the drain valve.
Notes:
①
Extra drain valve of external water pipe must be installing to ensure that the water in the
whole circulating water system can be completely drained.
②
Please open the discharge valve A and water discharge valve B connected to the outside
of the hydro box at the same time when draining of hydro box.
To Next Page
Loading...
