Gree KF-70DW/NA1 - Page 30

17.
18.
a.
14.
15.
16.
１３．
30
8-26
8-27
8-28
8-29
8-30
8-31
8-32
8-33
8-34
Dissassembly Procedures/ Photoes
Disassemble the bearing mounting plate
To screw off 4pcs bolt in the fig. with screwdriver.
Fig.
Bolt
Disassemble the motor
To loose the bolts in the fig with screwdriver,
can take out the motor clamp and motor fixing
hoop.
Disassemble the motor holder sub-assy
To screw off the bolts in the fig. with
screwdriver, so that can take off the
motor holder sub-assy.
Disassemble the motor holder, supporting
plate
Using the screwdriver to screw off the bolts
in the motor holder, rear side plate assy and
supporting plate.
Disassemble the left and right plates
Using the tool to take off the bolts
which are fixing the left and right
plates.(There are 2pcs M8 bolt and
2pcs M6 bolt)
Disassemble the motor support sub-assy
Using the screwdriver to take out the bolts
in the figure ;;
b. Using the tool to take out the bolts in the
fig, can take off the motor support sub-assy.
Fig.
Bolt
Fig.
Motor holder sub-assy
Tapping screw
Tapping screw
Fig. Fig.
Fig.
Fig.
Bolts
Tapping screw
Right holder plate
Bolts(4pcs)
Left holder plate
Fig.
Fig.