Operation procedures/pictures
Disassemble electric box
Earth wire
Electric box cover
Fig.
To push the left clasp of the electric box cover with screw
driver, and take out the elelctric box cover, and loose the
earth bolts on the evaporator. Take out the tube sensor.
(As shown in Fig.8-5, 8-6).
Fig.
Fig.
Tube sensor
Room sensor
Indoor unit
motor connector
Board of indicator light
Power cable terminal
Take off the indoor motor of the electric box, the connector of
swing motor. And take out of the electric box.
Pull out of the connection wire and power cord which are on
the connection wire terminal.
To screw off 3pcs bolts which fix on the board of indicator
light, and take the board of indicator light, wirless receiver,
and indoor sensors, out of the electric box. Prize up electric
box clasp. (As shown in Fig.8-5, 8-6)
To Next Page
Loading...