78
Test Operation, Troubleshooting and Maintenance
4.4.2 Replacement instructions
(1) LSQWRF35VM/NaA-M and LSQWRF35VM/NhA-M
Replacement of the compressor
Note: be sure there is no refrigerant inside the system and power supply has been cut off before
replacement.
Steps Image Instructions
1. Remove the
front panels.
• Remove screws at the front
pane.
• Loosened screws should be
put together to avoid loss.
• Pull the front panel upwards
and then remove it.
• Properly keep the removed
front panel to avoid from
being damaged.
• Note: there are two clasps
at each panel for connecting
with side panels.
2. Remove power
lines and the
electric heater.
• Remove the insulation of the
compressor.
• Loosen screws of power lines
with a screwdriver.
• Draw out power lines.
• Draw out the electric heater.
• Note: power lines and
their terminals should be
numbered to avoid incorrect
rewiring.
3. Disconnect
power lines to the
compressor.
• Desolder pipes quick to avoid
deformation.
• Keep the replaced
compressor complete for
further analysis.
To Next Page
Loading...
