GREE U-Match 5 SERIES UNIT SERVICE MANUAL
132
Disassembly of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
4. Remove the compressor
from the chassis.
Take out the compressor
and replace it.
Note: When replacing the
compressor, avoid touching
the nearby pipeline and
components.
5. Fix the new compressor back
onto the chassis.
After replacing the
compressor, tighten up the
screws at the foot of
compressor.
6. Connect the compressor
suction port and exhause
port with the pipes.
Weld the compressor
connection pipes and
connect them to the
compressor.
Note: When replacing the
compressor, avoid touching
the nearby pipeline and
components.
To Next Page
Loading...
