33
Technical Information
Service Manual
NOTICE:
● During operation, point the remote control signal sender at
the receiving window on indoor unit.
The distance between signal sender and receiving window
should be no more than 8m, and there should be no
obstacles between them.
● Signal may be interfered easily in the room where there is
fluorescent lamp or wireless telephone; remote controller
should be close to indoor unit during operation.
● Replace new batteries of the same model when
replacement is required.
● When you don’t use remote controller for a long time,
please take out the batteries.
● If the display on remote controller is fuzzy or there’s no
display, please replace batteries.
Emergency operation
If remote controller is lost or damaged, please use aux.
button to turn on or turn off the air conditioner. The
operation in details is as below: As shown in the gure, open
panel and press aux.button to turn off the air conditioner.
When the air conditioner is turned on, it will operate under
auto mode.
aux. button
6. Function and Control
To Next Page
Loading...
