Water Monitoring System
Ver.5.0.1 – Revision August 2022 Page 91 of 111
The specific appearance of the spare parts is
subject change without notice; the function
however will not change
• 1 x Wiper blade (set of 4 pcs.)
•
1 x Electrode for pH Sensor
•
1 x Gasket for pH Sensor
•
2 x O-ring PAH Chamber
•
1 x Turbidity O-ring
Recommended Spare Parts Kit for WM
and WMR for 1-year operation
•
1 x Wiper Blade (set of 4 pcs.)
•
1 x Electrode for pH Sensor
•
1 x Gasket for pH Sensor
•
2 x O-ring PAH Chamber
•
1 x Turbidity O-ring
Recommended Spare Parts Kit for WM30
Type A for 1-year operation
•
1 x Pump Impeller
•
1 x Shaft Seal
•
1 x End Cover
•
1 x O-Ring For End Cover
•
1 x Shaft V-Ring
•
1 x Electrode for pH Sensor
•
1 x Gasket for pH Sensor
Recommended Spare Parts Kit for WM30
Type B for 1-year operation
• 1 x Impeller for pump NBR Ø 55 mm
• 1 x Mechanical seal
• 1 x Wear plate without hole
• 1 x Wear plate with punched hole st.s
• 3 x O-Ring for impeller pump
• 1 x Tape
• 1 x Shaft Key
• 1 x Sandpaper
• 1 x Electrode for pH Sensor
• 1 x Gasket for pH Sensor
To Next Page
Loading...
Need help?
General
