31
EN
TECHNICAL DATA
NOTE: GREENCUT reserves the right to modify the specications of the device
without prior notice.
LED FUNCTIONS
USING THE PRODUCT
CHARGING THE BATTERY PACK
Battery packs are shipped in a low charge condition to prevent possible problems. Therefore, you
should charge them until the green LED on the front of the charger comes on.
CHARGING A HOT BATTERY PACK EN
When using a tool continuously, the batteries in the battery pack will become hot. You should
let a hot battery pack cool down for approximately 30 minutes before attempting to recharge.
NOTE: Refer to CHARGING A COOL BATTERY PACK for normal recharging of
batteries.
CHARGER
Model CHAR-40V
Input 100-240V / 50-60Hz AC
Output 40V 1,8A
Compatible Battery Pack BT402L (BAT-40V-2A) - BT404L (BAT-40V-4A)
MODE RED
GREEN
Stabdby power OFF ON
Charging OFF Flash
Full Charge OFF ON
Too hot too cold Flash Flash
Defective Flash OFF
To Next Page
Loading...