CARE AND MAINTENANCE
AWARNINGo
Befocc ettempting
to
pe;lonn
eny maintenance on this unit, tum ell
controls to
the "OFF" position and unplug. Allow the unit to be "OFF" for at least
10
minutes before any
maintenance applied in order to allow all components
to
cool down properly.
Cleaning:
1.
To remove dust, fingerprints
or
other marks from glass window, use clean damp cloth. Do not
spray glass cleaner
or
other liquid directly onto the glass.
2.
Clean metal surtilces with a clean damp cloth making sure not
to
push dust
or
debris into any
air intake
or
exhaust vents.
3. Do not usc abrasive cleansers or spray liquids on any part
of
the appliance.
4. Periodic cleaning vacuuming
of
the fan/heater unit
is
strongly recommended to ensure that no
diti
or
foreign objects build up.
Replacing Remote Control Battery
If
the remote controls stops functioning or operate poorly, the battery should be replaced with
new
one (model# CR2025).
1.
The battery compartment can be found on the back side
of
the remote control.
2.
Press and slide the batteJy door to open and remove the old battery.
3.
fnscri a
new
CR2025 coin battery, making sure that the
polarity"+"
and"-"
atchcs properly as
Illustration showing.
4. Close the
battery door.
Warning:
Like with any remote control unit, the remote control unit included with your fireplace may
unwantedly affect
or
control other electric products such as TVs.
If
this occurs,
you
can change
the encryption on your fireplace remote so that it will not affect other products. To change the
settings on your fireplace remote, hold down the Timer button on the fireplace remote for 3
seconds. To test, use your fireplace remote and see
if
your other products are still affected.
[f
so,
you may change your fireplace remote to a third encryption by again holding down the Timer
button on the remote for 3 seconds. To test this third encryption setting, use your fireplace remote
and see
if
your other products are still affected. To get back
to
the original encryption setting, hold
down the Timer button on the fireplace remote for 3 seconds.
Zero Clearance Fireplace
The electric fireplace has zero clearance safety technology, with the advanced zero clearance
safety sensor,
if
there is something covering
or
closing the slide outs, after about 20 seconds,
the appliance will switch
off
power
automatically. Then pull the plug out,
Let
the appliance
cool down for 3 minutes,
Plug the
power
cord again, the fireplace will be working again.
To Next Page
Loading...
