NG Hook up Guide
There are 6 screws on the rear panel of your grill. Remove them and carefully take the panel o.
Set aside screws for later.
Next, remove the front panel of
your grill. There are two screws on
both sides of the grill.
Once removed, you may need to
disconnect the four ignitor wires
from the panel. This allows for
easier access.
Remove the 2 screws holding
together the gas line. Set aside
screws for later.
Prior to installation make sure you have all the
neccessary equipment before moving forward.
In this kit you should have received:
NG regulator *1pc
NG Jet 1.85mm *4pcs
Before you begin your installation rst start by
taking o both the front control panel and rear
access panel.
* Keep all hardware
1
2
2-1
2-3
2-2
2-4
2-5
To Next Page
Need help?
General
