FD2200TS/ Translation of the original instructions
MAINTENANCE SUMMARY TABLE
PROCEDURE EVERY 8
HOURS
AFTER
20
HOURS
EVERY 50
HOURS
EVERY
100
HOURS
EVERY 250
HOURS
EVERY 1000
HOURS
Engine oil
check the level ●
change
●
(first
change)
●
Air filter
check ●
replace ٭
Hydraulic
oil
check the level ● ●
replace
●
(first change after
500 hours)
●
Check that the cooler intake
grid is clean ●
Check that blades are well-
sharpened and well-fixed
● ●
Lubricate with grease
● ●
● recommended procedure
٭ procedure to be carried out if necessary
LUBRICATION POINTS
Find the lubrication points following the scheme below. Grease the rear axle pivots, the pedals, the PTO
transmission belt guide pulley, the pivot connected to 2 points joint of the cutting deck, the grass catcher lifter arms,
the turbine shaft and the PTO tightener (fig. 24) every 50 hours.