TRIMMER-Translation of the original instructions
END OF SEASON MAINTENANCE
Thoroughly clean the machine, replace the engine oil (fig. 3, n. 13 – fig. 9, n. 22), clean the air filter
(fig. 3, n. 15).
MAINTENANCE SUMMARY TABLE
PROCEDURE AFTER 20
HOURS
EVERY 8
HOURS
EVERY 50
HOURS
EVERY 100
HOURS
EVERY 200
HOURS
Engine oil
Check the level ●
Replace ●
●
●
Air filter
Check ●
Replace ● ٭
Check that the engine intake
grid is clean
●
Lubricate with grease
●
● recommended procedure
٭ procedure to be carried out if necessary
IMPLEMENTS
GRASS-GUARD PROTECTION
This protections is recommended when cutting along streets and avenues to prevent the grass from
being thrown away (fig. 9). It can be mounted on the right side as well as on the left side of the
machine.
ANTI-SKID TOOTHED DISK KIT
These disks (fig. 10) can be mounted on the hub of the 3,50-8 wheels via the appropriate couplings
delivered with the kit. Combined with the wheels, this implement allows a greater grip on low-
adherence grounds and on slopes.
WARNINGS FOR TRANSPORT
Wheeled trimmers cannot be used on public roads. If the machine is to be transported on a lorry or a
trailer, lower the handlebar, engage the parking brake (fig. 2, n. 9), fasten the machine to the
lorry/trailer using ropes or belts. If a lifting machine is used to lift the wheels trimmers from the ground
into the lorry/trailer make sure its lifting capacity its suitable for the machine.
To Next Page
Loading...
Need help?
General
