Why is there no sound coming from my Ground Zero GZIA 1.600HPX-II?
If the POWER LED is not illuminated, check the fuses in the amplifier, ensure the remote lead is connected, verify the signal leads, recheck the control settings, and confirm the tuner/deck volume level. If the diagnostic LED is illuminated, inspect for a speaker short or amplifier overheating.
What to do if the Protection LED is on in my Ground Zero GZIA 1.600HPX-II?
If the Protection LED is illuminated, it could be due to a temperature shutdown. In this case, turn the radio volume down. Another cause could be shorted speaker wires; separate the speaker wires and insulate them.
How to fix a Ground Zero GZIA 1.600HPX-II Amplifier that's not switching on?
If your amplifier isn't turning on, the issue might be a lack of power to the amplifier. Check the power wire and its connections. Also, ensure that the remote wire is receiving power when the receiver is on; inspect the connections to the radio.
What to do if my Ground Zero GZIA 1.600HPX-II has no sound in one channel?
If there's no sound in one channel, inspect the speaker leads for a short circuit or an open connection. Also, check the audio leads by reversing the left and right RCA inputs to determine if the issue is occurring before the amplifier.
Why is my Ground Zero GZIA 1.600HPX-II turning off at medium/high volume?
If your amplifier is turning off at medium or high volume, check the speaker load impedance and ensure that the proper speaker load impedance recommendations are being followed.
General| Brand | Ground Zero |
|---|---|
| Model | GZIA 1.600HPX-II |
| Category | Amplifier |
| Language | English |
To Next Page