Debugging 7
1. Close the DC switch on the inverter. As long as the input DC voltage is greater
than MOV,the inverter display will show t he following information: No mains con-
nection error,the inverter LED will turn red.
If other information is displayed, please refer to Chapter 8.If you encounter any
problems during the debugging process and cannot solve it,please contact cus-
tomer service.
2. Close the circuit breaker or switch between the inverter and the grid, the in-
verter will start a countdown to the self -check,and after the self-check is normal,it
will be connected to the grid.
3.In normal operation,the leaves of the inverter indicator window will turn green.
4.Finish debugging.
To Next Page
Loading...
