44
Searching for television channels
from the cable provider manu-
ally
1 Open the menu with »MENU«.
2 Select the line »SOURCE SETUP« with »
V
«
or »
Λ
« and press
»OK«
to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
V
« or »
Λ
«
and press
»OK«
to confirm.
Select the option »Cable« with »
<
«, »
>
«,
»
V
« or »
Λ
« and press
»OK«
to confirm.
4 Select » Digital Manual Tuning« with »
V
« or
»
Λ
« and press
»OK«
to confirm.
– The menu appears.
5 Enter the four-digit frequency with »1 ... 0«
and press
»OK«
to confirm.
–
The search starts after confirming, the
channels found are displayed in the »Re-
sults« menu.
6 Press »MENU« to finish the setting.
SPECIAL SETTINGS
----------------------------------------------------------------------------------------------------------
Searching for digital terrestrial
TV channels automatically
1 Open the menu with »MENU«.
2 Select the line »SOURCE SETUP« with »
V
«
or »
Λ
« and press
»OK«
to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
V
«
or »
Λ
« and press
»OK«
to confirm.
Select the option »Air« with »
<
«, »
>
«, »
V
« or
»
Λ
« and press
»OK«
to confirm.
Caution:
7
The antenna power supply (line »Active
Antenna Power«) may only be switched on
if the antenna is an active indoor antenna
with a signal amplifier and it is not already
supplied with a voltage via a mains plug
(or similar supply). Otherwise you may
cause a short circuit and irreparably dam-
age your antenna.
4 Select the »Active Antenna Power« with »
V
«
or »
Λ
«. Switch on the antenna power supply
for the antenna with »
<
« or »
>
« (»On«).
5 Select the line »Automatic Channel Search«
with »
V
« or »
Λ
« and press
»OK«
to confirm.
– The menu appears.
Exit
Back
SOURCE SETUP
AUTOMATIC CHANNEL
SEARCH
20.09.2010
15:46
Start Search
Scan Type
Country
Connection Type
U.K.
Air
ATV & DTV
To Next Page
Loading...
