TUNING
SSB
(SINGLE SIDEBAND) continued
Turn
on the G6.
Tune
to
the shortwave frequency
of
your choice,
using the methods described.
To
use
SSB,
turn on the
SSB
circuit
by
pressing the
SSB
button. Note that
SSB
appears
in
the display.
Use
the tuning knob
to
FAST-tune
the
SSB
signal, then SLOW-tune
with
the tuning knob.
Press
the
JOG
button
to
change from 'Fast'
to
'Slow' tuning. The
SSB
circuit allows tuning
of
both upper and
lower sideband signals.
STORING STATIONS INTO
MEMORY
The
G6
has
700 memories (also called presets), arranged
in
100
pages (page 00-99),
with
each page holding 7 memories. Buttons
#1-7 represent memory locations. All memories
are
randomly pro-
grammable, meaning that any kind
of
frequency
can
be
stored into
any memory.
SSB
selection
is
not
stored.
Note that when storing into
an
already occupied memory position,
its contents will
be
replaced
with
your new entry.
1.
Turn
on
the
G6.
2.
Tune
to
the desired station.
3.
Press
the PAGEfflME button
to
place the G6 into MEMO mode.
4.
To
select the desired memory page (00-99)
use
the
AUTO
t ..
buttons.
5.
Store the station by pressing one
of
the #1-7 buttons
for
about
2 seconds or until the square around the memory location
in
the
LCD
blinks.
6.
To
store another station, get
out
of
memo mode by pressing
PAGEfflME and tune
to
the station; then repeat the steps above.
7.
When finished storing stations,
press
the PAGEfflME button
to
exit MEMO mode.
11
To Next Page
Loading...
