24 / 52 EN
Remote control / User Manual
8.7 FP function (Freezing protection)
The unit will operate at high fan speed (while compressor on) with temperature
automatically set to 8 °C/46 °F.
2
C
Note: This function is for heat pump air conditioner only.
Press this button 2 times during one second under HEAT Mode and setting temperature of 16 °C/60 °F
to activate FP function.
Press On/Off, Sleep, Mode, Fan and Temp. button while operating will cancel this function.
8.8 LOCK function
Go
Clean
5s
5s
Turbo
+
Press together GoClean button and Turbo button at the
same time more than 5 seconds to activate Lock function.
All buttons will not response except pressing these two
buttons for two seconds again to disable locking.
8.9 SET function
or
SET
SET
OK
•
Press the SET button to enter the function setting, then press SET button or TEMP or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the OK
button to confirm.
•
To cancel the selected function, just perform the same procedures as above.
8 How to use advanced functions
To Next Page
Loading...
