Grundig VISION 6 26-6840 T - OPERATION WITH COMMON INTERFACE; Inserting the CA module; Access control for CA module and smart card

ENGLISH
43
Inserting the CA module
Note:
Switch off the appliance before inserting the CA module in the
»
CI« slot.
1 Insert the smart card into the CA module.
2 Insert the CA module with the smart card into the »CI« slot on the
television.
Note:
To see which CA module is in the Common Interface slot, go to
the »CA - Module« submenu.
Access control for CA module and smart card
1 Open the menu with »i«.
– The »PICTURE« menu is displayed.
2 Select the »CHANNEL SETUP« menu with »
–
« or »
+
« and con-
firm with »
G«.
3 Select »CA–Module« with » V « or » Λ « and press »G« to
confirm.
Notes:
This menu give operating instructions and – after you enter your
PIN code – access to channels of the PAY-TV provider.
The remaining settings are described in the manuals for your CA
module and smart card.
4 Press »i« to finish the settings.
OPERATION WITH COMMON INTERFACE
CHANNEL SETUP
Auto Tuning
Digital Manual Tuning
Analogue Manual Tuning
Programme Table
Signal Information
CA - Module IRDETO ACCESS
Select
Back
Exit
Active Antenna Power On
s
s
s
s
s
Z
1