meter - ruining the fantastic
performance of the tweeter-
instead the Mojo s is provided
with a set of sockets for
Duelund Graphite resistors on
the back of the speaker.
Custom value resistors can be
purchased from your Gryphon
dealer. The resistors are pla-
ced in the clips and the leads
connected to the black termi-
nals. Be careful not to break
the resistors and make sure
that the leads are not
short circuiting to the
back plate or the other
resistor.
Standard setting/neutral:
R1 = 5.6 Ohm
R2 = 39 Ohm
Optional
Low setting: ( - 0.5 dB )
R1 = 10 Ohm
R2 = 15 Ohm
Optional
High setting: (+ 0.5 dB )
R1 = 3.9 Ohm
R2 = Empty
Tweak alert
Mojo s is the fruit of an extre-
mely protracted, very open-
minded development process.
We assure you that it is not
possible to improve this sys-
tem by replacing a few
lengths of wire or a capacitor.
The Mojo s stand
The enclosed spike and coas-
ter will ensure a optimal coup-
ling to the floor even on car-
pets and is adjustable for
vertical allignment of the
speaker.
Maintenance:
Custom paint in semi
gloss/high gloss two-pack
automotive paint with a very
hard surface. Only use a moist
soft cloth to wipe it . Do not
use any solvents of any kind.
Do not wax or polish.
Mojo s Speaker system
performance:
Frequency response:
37 Hz -32,000 Hz
Room dependent
X-over freq: 2000 Hz
4th order
Sensitivity:
89 db / 1W / 1m
Nominal impedance:
4 Ohm
Power handling:
200 Watts
Dimensions:
W: 42 cm D: 47 cm H: 122 cm
Net. weight
2 x 49 kgs.
Shipping weight:
2 x 91 kgs.
To Next Page
Loading...