1
T
M
DrawingBoard VI
Quick Start
Some digitizing applications (typically, non-Windows
CAD applications where the tablet is used solely as
a digitizer with no mouse functions) may not require the use of the TabletWorks software. If you need
to configure your DrawingBoard VI for use with a third-party application, please refer to the
configuration instructions in the DrawingBoard VI User’s Guide, found on our website gtcocalcomp.com
Contents
Verify that your DrawingBoard VI package includes the following:
DrawingBoard VI digitizing tablet
Transducer (corded or cordless pen, 4-button cursor,
or 16-button cursor)
USB Cable
DrawingBoard VI User’s Guide (visit gtcocalcomp.com)
DrawingBoard VI Quick Start (this document)
Warranty Sheet
Optional Equipment
RS232 cable with 9-pin connector for serial
connection
P
o
wer s
upply –
required
only for a serial
installation
Accessory Tray
Plan Holder
Universal Mounting Brackets
Table Feet
Check the insert in the large packing
box for some
of the items
listed here.
Install the software first, then set up the hardware connections for USB (or the optional serial).
Software Configuration
Software drivers provide the communication bridge between your software application and the DrawingBoard VI. GTCO
CalComp TabletWorks supports reduced functionality Wintab and TabCon-compatible applications. If you’re not sure about your
application’s driver requirements, contact your application vendor.
Installing Tabletworks
Visit gtcocalcomp.com/software-downloads/ to download.
To Next Page
Need help?
General
