GTCO CalComp Roll-Up III Quick Start

1
Installing Your Roll-Up III
The following instructions describe how to set up your Roll-Up III. Select a large, flat, non-metal surface on which to place the
Roll-Up III. Clear all items from the surface.
Setup the hardware connections for USB or serial FIRST,
following the instructions below, then install
the software.
Conductive materials, inks, or electronic
devices on, under, or near the Roll-Up III
can cause improper operation.
ConnectorsConnectors
ConnectorsConnectors
Connectors
PP
PP
P
oo
oo
o
ww
ww
w
erer
erer
er
(DC IN)(DC IN)
(DC IN)(DC IN)
(DC IN)
SerialSerial
SerialSerial
Serial
(RS-232)(RS-232)
(RS-232)(RS-232)
(RS-232)
TT
TT
T
ransducerransducer
ransducerransducer
ransducer
(POINTER)(POINTER)
(POINTER)(POINTER)
(POINTER)
USBUSB
USBUSB
USB
(USB)(USB)
(USB)(USB)
(USB)
Hardware Configuration
Quick Start
TM
Roll-Up III

Computer interface cable with 9-pin connector
for RS-232 serial connection

Power supply – required only for serial installations

Deluxe Travel Bag
Optional items, purchased separately:
Package Contents
Verify that your Roll-Up III package includes the following:

Roll-Up III digitizing tablet

Transducer (stylus or 16-button cursor)

USB Cable

Cardboard tube, insert and end caps – Do Not Discard

GTCO CalComp Roll-Up III Specifications

General

Type	Digitizer
Model	Roll-Up III
Manufacturer	GTCO CalComp
Category	Measuring Instruments
Technology	Electromagnetic
Resolution	1000 lines per inch
Accuracy	±0.01 inch
Power Supply	AC Adapter